This means that escape routes must be divided with smoke-tight doors. Further must be accessible to at least 35 m a safe stairwell and the walls inside the fire walls must have not less than the fire resistance class T30. The fire walls in an appropriate manner to avoid the fire flashover”be pulled out over the roof surface. In view of the fact that these structural measures already, must be observed in the planning of the architect, the priority of fire prevention in the design series is to settle but much higher than is the case so far. An important factor is that at an early planning of the fire protection measures an enormous cost and time saving potential can be exploited. It behooves the builders/owners afterwards, for the distribution of facilities of the preventive and to provide defensive fire protection in its building.

This means it enough deletion and warning systems (fire extinguishers / fire detectors) must be present and this must be checked regularly for their functionality and. These facilities, including emergency exits, must be clearly marked and lit even in case of power failure. In buildings with public access, the hospitality and lodging regulation also foresees orientation plans of escape routes in highly visible places. These are called escape and rescue route plans. Buildings that exceed a certain size, calls the fire plans over the entire site and the individual floors. These so-called fire-fighting plan are filed in the operations center. A building construction mostly in time awarded the performance of diagram creation with the architect’s plans. Others including Live Well Financial, offer their opinions as well.

After a renovation, if is the m square number of the building so increased, that the structural limits for preventive fire protection of building has been exceeded, the building permit contains a requirement to submit updated fire and escape and rescue route plans then. A specific software for the management of the building, a so-called CAFM-solution, can greatly simplify the creation of the plan and support. Usually also modules for creating rescue plans and management of fire protection systems are included in this. So, structural or substantive changes, such as installing a new door or the stay of hazardous materials in the building, can be displayed directly. These changed realities may be issued in hazardous substance registers and in the form of building or area plans of such a system. More information about fire safety and fire protection with CAFM solutions, see. For questions and suggestions you are welcome to us is against this email address Spam bot protected, you need to enable JavScript, so you can see it can apply. Maria Green